For use in the ANKOM Dietary Fiber Analyzer.
This bag is used in the upper section when only a Total Dietary Fiber (TDF) value is required. The DF-FT bag allows the entire contents of the enzymatic digestion to Flow Thru to the lower SDF chamber.
Bags are sold in quantities of 100. Discounts are applied at quantities of 300 (3 packages of 100) and 1,000 (10 packages of 100).
For use in the ANKOM Dietary Fiber Analyzer.
This bag is used in the upper section to capture the Insoluble Dietary Fiber after the enzymatic digestion.
Bags are sold in quantities of 50. Discounts are applied at quantities of 300 (six - fifty count packs) and 1,000 (twenty - fifty count packs).
For use in the ANKOM Dietary Fiber Analyzer.
This bag is used in the lower section to capture and precipitate the Soluble Dietary Fiber (SDF) after the IDF digestion.
Bags are sold in quantities of 50. Discounts are applied at quantities of 300 (six - fifty count packs) and 1,000 (twenty - fifty count packs).
The largest contributor to poor TDF results is the effect of static electricity on the weighing process.
The TDF52 Bag Weigh Holder is used during the weighing process to eliminate static electricity while the bag is being weighed.
The last step in the Dietary Fiber extraction process is to rinse the samples with acetone. That process is not done on the ANKOM TDF instrument.
The TDF51 Bag Rinse Stand is used to hold the Filter Bags during an Acetone Rinse.
Before the final weighing step in a Dietary Fiber analysis, the bags must be dried.
The TDF50 stainless steel Bag Drying Rack has twelve positions for holding a full set of IDF/SDF bags when drying them in an oven.
At various times during assays involving ANKOM instruments you will need to seal the ANKOM Filter Bags.
The HS Heat Sealer (120v 50/60HZ) is used for sealing ANKOM Filter Bags.
Before doing a dietary fiber assay, you should label the filter bags in order to properly record results.
Use this marker for labeling the filter bags.
At various times during assays involving ANKOM instruments you will need to seal the ANKOM Filter Bags.
The HSi Heat Sealer (220v 50/60HZ) is used for sealing ANKOM Filter Bags.
Please specify the country in which the heat sealer will be used so that ANKOM can supply the proper power plug.
Replacement cover for the 120v and 220v Heat Sealers (P/N: HS, HSi). This is applied over the heating element and held in place with clamp strips. For installation diagram refer to Heat Sealer Operation Manual.
Replacement Insulator Strip on the 120v and 220v Heat Sealers (P/N: HS, HSi). This is adhesive-backed and positioned beneath the heating element. For installation diagram refer to Heat Sealer Operation Manual.
Replacement Silicone Rubber Gasket for upper pressure bar (in handle) of the 120v and 220v Heat Sealers (P/N: HS, HSi). For installation diagram refer to Heat Sealer Operation Manual.
The Moisture Stop Weigh Pouch contains a desiccant packet which absorbs moisture within the zipper bag. It is used when cooling and weighing filter bags to avoid unwanted absorption of moisture in the dried samples which would skew results.