FAQ Category
FAQ Group
- (-) Remove Instrument set-up filter Instrument set-up
- Assays and Methods (11) Apply Assays and Methods filter
- Consumables (7) Apply Consumables filter
- Controller Problems (4) Apply Controller Problems filter
- Filling Problems (4) Apply Filling Problems filter
- Check Packing (3) Apply Check Packing filter
- Maintenance and Service (3) Apply Maintenance and Service filter
- Results (3) Apply Results filter
- Pressure Error (2) Apply Pressure Error filter
How do I set up my instrument for the different fiber analyses (NDF, ADF & Crude Fiber)?
How do I set up my instrument for the different fiber analyses (NDF, ADF & Crude Fiber)?
In order to properly set up your instrument for the various fiber analyses, refer to the instrument images in your A2000 Operator's Manual under the section titled Instrument Description.
Fault Screen "Cold Rinse used" "Reset . . . [ENTER]"
Fault Screen "Cold Rinse used" "Reset . . . [ENTER]"
Possible Causes:
Rinse water supply temperature did not meet method standards. This may affect results with certain samples. Make sure the water supply has a temperature no less than 50°C for Crude Fiber, or no less than 70°C for ADF and NDF determinations. This message will be displayed at the end of an analysis so your results may be affected. A small water heater dedicated to the A2000 instrument will help. Contact ANKOM for assistance as needed.